Axing EOC 2-00 Service Manual download pdf (Page 13)

2015-01-19 | © AXING AG Schweiz | Konstrukions -, Typenänderung, Irrtümer und Druckfehler vorbehalten 13

5.2. Operation Mode

The main page, called "Setup Wizard" offers you the most basic settings needed for Wi-Fi operating mode.

After selecting one of the following options, you will be guided through the installation process.

You are able to choose one of the following functions:

Bridge AP

In this mode the device acts as a single access point. The network the device is attached to is being extended

via the LAN ports (device acts as switch) and via the Wi-Fi interface.

If EoC feature is used, the EoC network is also being bridged. This means, every device connected to the EoC 2-

01 network is automatically part of the network the EoC-device is part of.

Attention: NAT disabled, same IP-Address-Range, if there is a DHCP-Server in the existing network, this Server

also assigns IP-Addresses in the network of the EoC 2-01. There is no need to configure a network-internal

DHCP-Server separately.

Bridge Client

In this mode the device connects to a manually selected wireless Access Point. The device acts as a wireless

client.

Every port of the EoC 2-01, including LAN and Wi-Fi is bridged. This means, every device connected to the

EoC 2-01 network is automatically part of the wireless network the device is connected to.

Attention: NAT disabled, same IP-Address-Range, if there is a DHCP-Server in the existing network, this Server

also assigns IP-Addresses in the network of the EoC 2-01. There is no need to configure a network-internal

DHCP-Server separately.

Attention: The EoC 2-01 is not able to connect to existing networks, which use WPA in this mode.

AP & Client

In this mode the device acts in the same mode as "Bridge Client" - but the EoC 2-01 device creates its own Wi-

Fi network with the settings you have to enter during the installation process.

During the installation process you will have to select to which Wi-Fi network the device should connect to.

The web-front-end offers you a "Wireless Site Survey" at that specific installation point.

Attention: Please note that the newly created network uses the same channel as the network to which the

device connects to.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Axing EOC 2-00 Service Manual Page 13